A-A-2523B
3.9.1 Pockets. The interior of the lid shall have a file pocket with a
minimum of two tiered full-size compartments, two exterior compartments and two
adjustable retaining straps. The file pocket shall be chipboard covered with
either fabric, leather or expanded vinyl. Each full-size compartment shall open
to a minimum of 14 1/2 inches by 9 inches with the retaining straps attached.
Nylon binding shall be placed around the outermost folio pocket edge. The
method of attachment to the lid shall be the manufacturer’s standard commercial
practice and shall withstand the file pocket test without loosening from the
lid (see 4.6.4).
The pockets shall be completely enclosed on the front, bottom, and sides except
that a space on the sides at the bottom, not to exceed 2 inches, may be open.
The pockets shall be held closed by 2 retaining straps, one on each side near
the top. The file pocket shall have a minimum of two small accessory pockets
and two pen loops on the outer surface. An additional small accessory pocket may
be substituted for the pen loops. The accessory pockets and pen loops shall be
made from leather or artificial leather and sewn to the file folder section.
3.10 Marking. The cases shall be marked with the manufacturer’s name,
trade name, or trademark of such known character that the source may be readily
determined.
3.11 Workmanship. The completed case shall present a neat, finished
appearance both inside and outside, and shall exhibit no evidence of sharp,
jagged, or rough frame crimping or other unfinished components. There shall be
no sharp edges or points on the exterior or interior. The case shall be free
from defects which may affect durability, serviceability, or appearance.
3.12 Regulatory requirements. The offeror/contractor is encouraged to
use recovered materials in accordance with Public Law 94-580 to the maximum
extent practicable.
3.13 Metric products. Products manufactured to metric dimensions will be
considered on an equal basis with those manufactured using inch/pound units,
provided they fall within the tolerances specified using conversion tables
contained in the latest revision of FED-STD-376, and all other requirements of
this commercial item description are met.
3.14 Commercial item. The use of the term “commercial item description”
in this document does not imply that any item or items offered are not required
to conform with all requirements specified herein.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business